Zooper BU828EZ Manuel d'utilisateur télécharger pdf

Do not fold your stroller when wet.

Machine wash removable seat and armrest covers using gentle cycle,

cold water, and a mild detergent. The canopy can only be spot washed.

Line dry fabric parts.

Never use bleach when washing.

Do not leave your stroller in direct sunlight for extended periods of time.

Clean and lubricate all moving parts on the stroller frame and wheels

as needed. Use only a penetrating silicon based lubricant.

Regularly check for loose screws, broken parts, etc. Use only Zooper

approved replacement parts available through the service centers listed below.

Wipe off any sand, salt or other corrosive residue after each use where the stroller

may be exposed to those elements.

MAINTENANCE

IMPORTANT CARE AND SAFETY INFORMATION

WARNINGS

INTERNATIONAL MODEL NUMBER: BU828E/Z

IMPORTANT: READ THESE SAFETY INSTRUCTIONS CAREFULLY BEFORE USING

YOUR STROLLER AND KEEP THEM FOR FUTURE REFERENCE. THE SAFETY OF

YOUR CHILD DEPENDS ON IT.

Thank you for choosing Zooper.

UNLOCKING & OPENING THE FRAME

1 42

INTERNATIONAL MODEL NUMBER: BU828E/Z

User Guide

Hula BU828E/Z

INTERNATIONAL MODEL NUMBER: BU828E/ZINTERNATIONAL MODEL NUMBER: BU828E/Z

Avoid serious injur y from falling or sliding out, always use safety harness provided.

Always engage the rear brakes when not holding onto your stroller.

Never leave your child unattended.

Never use the stroller near an open fire or exposed flame.

Never allow the stroller to be used as a toy.

Never allow more than one child at a time in the stroller.

Never hang bags or other items from the handle or on the canopy. This may

cause the stroller to become unstable.

Never use the stroller on stairs or escalators.

Do not overload the basket. Maximum load is 7 lbs. Excessive weight may cause

a hazardous unstable condition to exist.

Do not overload the canopy pocket: Maximum load is 2 lbs. Excessive weight

may create a hazardous unstable condition to exist.

Before each use, check to make sure the stroller is set up properly and that all the

wheels are properly and securely attached.

This stroller is not recommended for use with a child over 55 lbs.

This stroller is designed as a walking stroller. We do not recommend running,

roller blading, or other such activities with this stroller.

This stroller is a single stroller do not use any attachments that allow for a second

child.

It may be unsafe to use accessories other than those approved by the

manufacturer or distributor.

We recommend you choose a good floor surface. Your

Zooper has a strong metal frame that could scratch

hardwood floors or other sensitive surfaces. To open the

stroller, first lift up on the red colored frame lock located

on the left side of the stroller,(Fig. 1). Be sure the frame

lock detaches from the metal locking pin. Grasp the

handle and pull back and up so that the stroller frame

opens (Fig. 2). Step down on the foot block while pulling

back on the handle so that the frame snaps open (Fig. 3).

WARNING: Be sure children are at a safe

distance and cannot reach moving parts whenever

opening or closing the stroller.Always make sure the

stroller has opened fully by checking to see that the

metal bars connecting the foot block to the frame are

straight and parallel to the ground.

REAR WHEELS

To install the rear wheels, line up each wheel block with a

rear leg tube (Fig 4). The brake levers must be facing out,

away from the stroller. Locate the spring lock buttons on

the outside of the rear leg tubes. Make sure the buttons

are coming out of the buttonholes and have not slipped

inside the tube during shipping. If you are missing a

spring lock, please contact the appropriate ser vice

center listed at the back of these instructions for

replacement parts. Push the rear wheel block onto the

rear frame leg until it clicks onto the spring lock button.

Then repeat for the other wheel block. Check visually

that the buttons have popped out of the small holes on

the outside of the wheel assembly. Pull out on each

wheel block to make sure that it has locked into place.

SECURING INFANT CARRIER

It is possible your infant carrier will NOT be compatible

with this stroller. Therefore, for first-time installation,

evaluate according to these directions without your

child in the carrier. To install the infant carrier, first be sure

it has been removed from the car seat base. Then

remove the armrest of the stroller and insert the thin

adaptor bar just as you would the armrest (Fig. 14).

Recline the backrest about 3/4 of the way down enough

so that your carrier will fit level onto the stroller seat.

Place the carrier onto the stroller so that the mounting

notch of the infant carrier fits onto the adaptor bar,

(Fig.15), and the front of the carrier rests on the backrest.

(If the mounting notch of your carrier is too small to fit

onto the adaptor bar, then position the entire carrier

between the adaptor bar, or armrest, and the backrest.

As long as it fits level onto the seat and can be secured

as described below, then it is still compatible with the

stroller). The restraint safety strap attaches to the two

metal D shaped rings on either side of the seat belt.

Place the restraint safety strap through the provided

spaces on each side of the car seat (auto seatbelt

path), or over the top of the carrier if your model does

not have that opening. Now adjust the strap to tightly

secure the carrier to the stroller. The tighter that you set

this strap will directly affect how secure the car seat

feels in the stroller. A well-tightened strap will be easily

demonstrated by lifting the entire stroller and car seat as

one solid unit, by the bar of the car seat.

WARNING: Do not use an infant carrier if it does

not secure to the stroller as described above. Any

infant carriers rated for weights over 20 lbs are also not

compatible with this stroller. Excessive weight may

cause a hazardous unstable condition to exist.

WARNING: Only the following infant car seat

models are compatible with this stroller: Graco - Snugride,

Peg Perego - Viaggio, Britax - Companion.

INTERNATIONAL MODEL NUMBER: BU828E/Z

USING THE BRAKES

To engage the brakes, step down on each rear brake

lever located between the two whee. (Fig. 11).Always

check that the

brakes have fully engaged by pushing for ward on the

stroller to make sure it stays in place. Lift the brake levers

with your foot to release the brakes.

WARNING: Do not use stroller if the buttons do

not properly pop out and lock the rear wheels in place.

Contact the appropriate ser vice center listed at the

back of these instructions for replacement parts.

Fig.1

Fig.2

Fig.3

Fig.4

SCREW AND NUT

FRONT WHEEL BLOCKS

Line up each front wheel block with the front leg and push

firmly together (Fig. 5). Always check to see that the

wheels have been properly installed by pulling out on the

wheel block. It should be locked to the front leg. To

remove, push in on the looped metal retention clip

located on the underside of the wheel block, and pull the

wheel block off.

Fig.5

ARMREST

To install the armrest, pinch in and push up on the

underside of the armrest clip (Fig 6). Remove the clip

completely. Slide the armrest into the slots and reinsert

the clip. Snap the fabric crotch strap around the armrest.

To open armrest from either end, pinch in on the clips as

noted above and swing the armrest out. The entire

armrest can be removed by pulling out both clips.

WARNING: Never pick up stroller by the armrest.

CANOPY

The canopy may also be used

as a napper canopy. Locate the zipper on the rear rib of

the canopy. When unzipped, the canopy will fall forward

over the bumper bar, completely shading baby from the

world.

The canopy attaches onto the stroller frame above each

side armrest (Fig. 7). Push firmly to install. Open the

canopy by pushing down on the plastic side canopy

braces. Be sure to snap the canopy to the sides of the

seat and backrest fabric. Retract the canopy by first

pulling up on the side braces then pushing the canopy

hood back. The canopy can be converted to allow more

air flow through the stroller.

Unzip the lower half of the canopy from the upper

half. This will leave a mesh cover that can snap to the

back of the seat. To remove the canopy, first undo the

snaps. Then press the release tabs, located on the plastic

slots, while pulling up on the canopy shafts.

WARNING: Do not tr y to retract the canopy when

the side canopy braces are fully open or with the sun visor

extended. This may damage the canopy. Whenever

the seatback is in the fully reclined position, make sure

that the canopy snaps or mesh snaps are buttoned onto

the back and sides of the seat fabric. Do not overload the

canopy pocket: Maximum load is 2 lbs (1 kg). Excessive

weight may create a hazardous unstable condition to

exist.

Fig.6

ADJUSTING THE SEATBACK

To lower the backrest, lift up on the plastic lever located in

the middle of the seatback and move the seatback down

into desired position. Then release the lever to secure the

seatback (Fig. 8). To raise the backrest, push up on the

back of the seat until it clicks into the desired position.

WARNING: Always keep your child in sight when

making these adjustments. Check the fitting of the safety

harness each time the backrest is adjusted to be sure a

snug, yet comfortable fitting is maintained.

SAFETY HARNESS

Zooper provides a special 5-point harness safety system

on all our strollers. Used properly,this harness will keep your

child seated and safe. To secure your child in the harness,

push buckles (A) and (B) into the buckle housing (C) until

the buckle prongs snap into position. Carefully adjust

slider (D) to fit snugly and comfortably around your child

(Fig. 9). Follow the same procedure to adjust the shoulder

straps. Always retighten the harness when your child is in a

sit up or layback position.

WARNING: Avoid serious injur y or death from

falling or sliding out. Alwaysuse the seat belt. Never leave

your child unattended.

LEG REST

To lower the leg rest, push up on the lever located on the

underside of the seat (Fig.10). To raise, simply push up on

the leg rest.

WARNING: Never allow your child to sit on the leg

rest. This may result in injury to your child and/or damage

to your Zooper. Children should always be properly

seated with the safety harness fastened.

Fig.8

Fig.10

WARNING: Always engage the both brakes

when you are not holding onto the stroller and check

that the brakes have been properly engaged as

described above. Always engage the brakes when

putting your child in, or taking your child out, of the

stroller.

SWIVEL WHEELS

The swivel-locking lever is located on the back of the

front wheel block where it meets the frame (Fig. 12).

Push the lever up to allow the front wheels to swivel. To

lock the wheels into a fixed position, push down on the

locking lever and move the stroller forward. The wheels

will lock automatically. The wheels should be locked in

the fixed position when walking over uneven surfaces.

FULLY ENCLOSE THE CARRIAGE

SPACE

Follow these steps to enclose the seat area whenever

the backrest is fully reclined: First remove the armrest.

Then lift leg rest fabric over and off the plastic leg rest

extenders. Zip both sides of the leg rest fabric onto the

sides to the seat fabric (Fig. 13). Zip down fully and

completely. Secure the armrest back onto the stroller.

WARNING: Your child may slip into leg openings

and strangle. Never use the stroller with the backrest fully

reclined unless the leg rest fabric is fully and completely

zipped together to the seat fabric and the canopy is

properly snapped onto the seat and backrest.

Fig.11

Fig.12

Fig.13

Fig.14

Fig.15

ADJUSTABLE HANDLE

To extend the handle, press the metal button located on

the plastic tube brace just below the handle. With the

button held down, pull the handle out into the desired

Position (Fig. 16). There are two extension positions. To

lower the handle, press the metal button as above and

push the handle down.

WARNING: Never hang bags of any kind or other

items from the handle. This may cause the stroller to

become unstable.

CLOSING THE STROLLER FOR TRAVEL

OR STORAGE

Each time, before closing your stroller, check the

following:

Your child is clear of moving parts

The rear brakes have been set

The backrest is in the full, upright position

The front wheels are secure in the locked mode

The canopy is retracted

All items have been removed from the basket

Never attempt to fold or close your Zooper with your

child inside

First release the primar y lock by lifting the foot block up

with your foot (Fig 17). Then lift up on the secondary lock

tab, just above the foot block, to release the frame. Then

step down on the safety lock located on the right side of

the stroller(Fig 18). Push the handles forward and collapse

the stroller down into the folded position (Fig 19). Check to

be sure the red frame lock secures to the locking pin.

Fig.16

Fig.17

Fig.18

Fig.19

Shoulders

Straps

Fig.9

Fig.7

User Guide 1

Résumé du contenu

Page 1 - User Guide

Do not fold your stroller when wet.Machine wash removable seat and armrest covers using gentle cycle, cold water, and a mild detergent. The canopy can

Commentaires sur ces manuels

Pas de commentaire

Zooper BU828EZ Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Poussettes Zooper BU828EZ. Zooper BU828EZ User's Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Poussettes Zooper BU828EZ